Inbound delivery not Created After GI while SPED output type

[former_member190537]

Hi,

We have are trying to set-up the standard function to copy the outbound delivery for STO into an inbound delivery by using the SPED output type.

We have performed all the config for the SPED output set-up as per OSS notes 965176 and 1119073

The access sequences and output determination procedures are set and the requirement type 408 is assigned to the determination procedure as per OSS notes.

Getting below error: After GI in Out determination of Delivery.

No goods receiving point for the combination of plant 1801 and stor.loc.

Message No. VL377

No inbound delivery created for the replenishment delivery 0080000030

Message No. /SPE/STO_HANDLING002

We have performed the set-up in VV21/VV22 for the SPED output type and assigned this to the delivery type NLCC.

Upon PGI of the outbound delivery the SPED output is not being triggered.

STO Created (Intercompany)

Suppling Plant ( Vendor) 1101

Receiving Plant                1801

Delivery created and maintained Output type SPED

After creation of GI got above said errors.

[former_member188914]

Hi,

What is the storage location in outbound delivery ? For goods receiving point error try maintaining an entry with plant , storage location blank and shipping point in SPRO for "Assign goods receiving point for inbound deliveries". Also, refer this note: 1541955, might be helpful to you.

Regards,