Intro
In this series I am talking about S/4HANA aATP Supply creation-Based Confirmation (SBC). We are now at the last part 4, to discuss a complex SBC use case and create an example for it in the system:
Part 1 - SBC Functional Overview
Part 2 -...
Intro
In this series I am talking about S/4HANA aATP Supply creation-Based Confirmation (SBC). We are now at part 3, to discuss a simple SBC use case and create an example for it in the system:
Part 1 - SBC Functional Overview
Part 2 - SBC Setup...
Intro
In this series I am talking about S/4HANA aATP Supply creation-Based Confirmation (SBC). We are now at part 2, to discuss how to setup SBC:
Part 1 - SBC Functional Overview
(current one) Part 2 - SBC Setup Guide
Part 3 - SBC Simple Use C...
Intro
In this series I would like to give you an overview starting from basic level gradually developing to advanced level about how the previously released Supply creation-Based Confirmation in S/4HANA aATP is built, how it works, how you can setup,...
Hi Lars,
yes, the material in the sales plant has to be marked for advanced planning so that PP/DS can take care of it, but the material does not need to have any BOM or routing. PP/DS will create an STO based on the special procurement setting only...
Hi Lars,this is already working today in case of PPAC. You can maintain the special procurement type (eg.: STO from Plant XXXX) for your material in the material master on view MRP2. With this, during the ATP check with PPAC and Supply Creation, PP/D...
Hi Christian,it looks like PP/DS is not active in your case for your planning version (or there is no active planning version at all). Probably the flag in table /SAPAPO/APO01 is missing for PP/DS for you planning version, which is quite a basic sett...
Hi Pravin,
you are correct, I suggest using PPAC in case you need fixed pegging functionality, there is no additional development required for that to work. Details are best to read in the online documentation for fixed pegging.
Regards, András
Hi Christian,
as mentioned in the 2nd part of the blog, you need to set Planning procedure 3 in the material master on the "Advanced Planning" Tab:
PP Planning Procedure (choose one)
3 – Cover dependent requirements immediately (for finished p...
