Hi Experts,
We have a requirement where we want to set planning threshold limit (weight/volume) per stop while doing optimizer planning. For example, FUs with less than 500 LB should not be a stop in Freight order. Kindly provide your thoughts to a...
Hi Experts,
I have created a Charge Calculation Sheet(TCCS) with multiple charge types. Few are Manual charge types and few are determined from Rate tables.
In Freight Order, I want to display only the charge type with values. If no value found ...
For US Fuel calculation, we have fuel surcharge calculated based on regions. We need to maintain multiple index tables (PADD1, 1A, 1B,1C,2,3,4,5). Is it possible to have rate table determination rule to determine Fuel Index rate table based on region...
Hello Experts,
During Forwarding Settlement posting in S/4 1809 TM Embedded, found system is looking for Distribution channel(TM VTWEG) and division(TM SPART) in table /SCMTMS/C_COMMON to post Service SO and Billing document. Without this, getting ...
Hello Experts,
We are implementing TM Embedded with S/4 HANA 1809 Shipper scenario(Advanced Shipping functionality). We have a requirement where our client works as a Transportation Service provider as well. For this, we created forwarding document...
Hi k.kumar13,Hope you have cost distribution enabled in your FO/FSD type. If not needed, you can deactivate in FO and FSD type anf then try with new documsnt.If needed, check your cost distribution profile in your charge profile and make sure the rul...
Hi surajit233,
Thank you for the response. Still, we can reverse the FSD and post new FSD with new set of charges. Did you faced any challenges with this approach?
Regards,
Karthik
Hello surajit233,
Thank you for the blog. I have a question - If we create separate SPO and SES (using delta FSD) for this difference amount, we can post cost distribution in standard way also right?
Regards,
Karthik
